How To Wrap An Extension Cord

Post Disclaimer

101 Generator is supported by its audience. When you purchase through links on our site, we may earn an affiliate commission. Learn more

How To Wrap An Extension Cord

How To Wrap An Extension Cord

To wrap an extension cord and connect the male and female ends together, you will need the following materials:

  • The extension cord
  • Electrical tape or a cord wrap

How To Wrap An Extension Cord

Here are the steps to wrap an extension cord and connect the male and female ends together:

  • Make sure all outlets and gadgets are unplugged from the extension cord. You should take this vital safety measure because you will be working with electrical cables.
  • Find the cord’s male and female ends. The female end is often the one with the sockets or receptacles, while the male end is typically the one with the prongs or plugs.
  • With the plug or socket pointing away from you, hold the cord’s male or female end in your dominant hand.
  • Start by wrapping the cord around your hand, making sure to maintain it as tight as you can.
  • Try to keep the individual wires as separate as you can while you wrap the cord. As you coil the cord, this will aid in avoiding tangles and knots.
  • Up until you have about 6 inches of cord remaining, keep wrapping the cord.
  • With your thumb and forefinger, secure the cord that has been wrapped.
  • Wrap the cord with the electrical tape or cord wrap, locking the wrap in place. To prevent the cord from unraveling, wrap it tightly with tape or cord wrap.
  • On the opposite end of the cord, repeat the procedure.
  • After wrapping the cord on both ends, join the male and female ends by slipping the male end into the female end.

You’re done when you plug the cord back into the appliance or outlet.

You can roll up the extension cord and join the male and female ends by following these instructions. When working with any electrical device or appliance, keep in mind to exercise caution and adhere to established safety precautions.

How Can Current Be Avoided While Wrapping The Extension Cord?

You should be sure to unhook the extension cord from any outlets or devices before you start the wrapping process to prevent getting shocked or electrocuted. By doing this, you can be sure that the cord is not active and that no current is passing through it as you handle it.

You should unplug the cord in addition to not handling it with damp hands or getting it wet. It is unsafe to come in contact with a wet extension cord because water and electricity do not mix. Finally, when using any electrical appliance or gadget, always proceed with caution and according to the correct safety precautions.

FAQs (Frequently Asked Questions)

How do you wrap an extension cord without tangling it?

Ans: Start by wrapping the extension cable around your hand, allowing a few inches of slack, to prevent tangling. Then, starting at the plug end and working your way up, wrap the cord around itself in a figure-eight manner. The cord should then be taped or secured with a twist knot.

Video Help:

For more Info must watch this!

Leave a Reply